Publicidad
Idiomas disponibles
Idiomas disponibles
Translation of the original opera-
GB
ting instructions
Cordless industrial straight
grinder IGS/A
WARNING!
Read all safety warnings, instruc-
tions, illustrations and specifica-
tions provided with this power tool.
Failure to follow all instructions listed
below may result in electric shock, fi re and l or
serious injury.
Save all warnings and instructions for future
reference.
Never work without dust protection
mask. Some dusts have a hazardous
effect! Materials containing asbestos may
not be machined! Ensure good ventilation of the
workplace.
Wear safety glasses! Flying splinters can
cause eye injuries.
For your safety, always wear hearing pro-
tection while working!
For use in dry environments only!
Protection class II device
Please do not dispose off the machine!
Safety warnings common for grinding, sanding,
wire brushing, polishing, carving or abrasive
cutting-off operations:
a) This power tool is intended to function as a
grinder, sander, wire brush, polisher, carving
Read all safety warnings,
or cut-off tool.
instructions, illustrations and specifica-
tions provided with this power tool.
re to follow all instructions listed below may re-
sult in electric shock, fire and/or serious injury.
b) Do not use accessories which are not spe-
cifically designed and recommended by the
- 12 -
tool manufacturer. Just because the accesso-
ry can be attached to your power tool, it does
not assure safe operation.
c) The rated speed of the grinding accesso-
ries must be at least equal to the maximum
speed marked on the power tool. Grinding
accessories running faster than their rated
speed can break and fl y apart.
d) The outside diameter and the thickness of
your accessory must be within the capacity
rating of your power tool. Incorrectly sized
accessories cannot be adequately controlled.
e) The arbour size of wheels, sanding drums
or any other accessory must properly fit the
spindle or collet of the power tool. Accesso-
ries that do not match the mounting hardware
of the power tool will run out of balance, vibrate
excessively and may cause loss of control.
f) Mandrel mounted wheels, sanding drums,
cutters or other accessories must be fully
inserted into the collet or chuck. If the man-
drel is insuffi ciently held and/or the overhang of
the wheel is too long, the mounted wheel may
become loose and be ejected at high velocity.
g) Do not use a damaged accessory. Before
each use inspect the accessory such as ab-
rasive wheels for chips and cracks, sanding
drum for cracks, tear or excess wear, wire
brush for loose or cracked wires. If power
tool or accessory is dropped, inspect for
damage or install an undamaged accessory.
After inspecting and installing an accesso-
ry, position yourself and bystanders away
from the plane of the rotating accessory
and run the power tool at maximum no-load
speed for one minute. Damaged accessories
will normally break apart during this test time.
h) Wear personal protective equipment. De-
pending on application, use face shield,
safety goggles or safety glasses. As appro-
priate, wear dust mask, hearing protectors,
gloves and workshop apron capable of
stopping small abrasive or workpiece frag-
ments. The eye protection must be capable
of stopping fl ying debris generated by various
operations. The dust mask or respirator must
be capable of fi ltrating particles generated by
your operation. Prolonged exposure to high in-
Failu-
tensity noise may cause hearing loss.
i) Keep bystanders a safe distance away from
work area. Anyone entering the work area
must wear personal protective equipment.
Publicidad
