Publicidad
Idiomas disponibles
Idiomas disponibles
•
The ignition key is in the STOP
position.
•
The cutting deck is disengaged.
•
The remote control is put to off.
•
Do not operate the product with the remote control
in the traffic or across a road. Be careful when you
cut grass near a road. Keep a safe distance from the
traffic.
•
Stop the blades when you move across areas that
you do not cut.
•
Only use the product with the remote control in
daylight or in other well-lit conditions. Keep the
product at a safe distance from holes or other
obstacles in the ground. Look out for other possible
risks.
•
Do not operate the product with the remote control
near edges, ditches or banks. The product can
suddenly overturn if a wheel moves across the edge
of a steep slope or a ditch, or if an edge breaks.
Make sure that the surface is sufficiently stable for
the product weight. Refer to
82 .
•
Do not try to stop the product if it starts to skid
or overturn. The product is heavy and can cause
serious injury if it falls.
Work area safety in remote control mode
WARNING:
no persons, children or animals in the work
area. If a person or animal enters the area,
immediately stop the product.
•
Remove stones, branches and other obstacles.
•
Look out for bystanders, objects and situations that
can prevent safe operation of the product.
•
Stay in correct operation distance when you operate
the product with the remote control.
1929 - 003 - 05.12.2023
Technical data on page
Make sure that there are
5m
15m
50m
Correct operation distance
During operation with cutting
deck engaged
During operation with cutting
deck disengaged
•
Before you change your operating position during
operation with the remote control, stop the product
and apply the parking brake from the remote control.
•
Make sure that you are in a safe and stable position
during operation
•
Do not stay behind or in front of the product when
the product is operated with the remote control.
•
Be careful when you operate the product near an
obstacle, wall or slope. The product has articulated
steering, the rear end of the product moves in the
opposite angle from the front end.
•
Do not start or stop on a slope.
•
Always stop the blades, apply the parking brake and
stop the engine before you enter the work area.
To cut grass on slopes in remote control mode
WARNING:
instructions that follow before you use the
product.
•
To cut grass on slopes increases the risk that you
cannot control the product and that it overturns. This
can cause injury or death.
•
This manual cannot include all situations that can
occur when you use the product. Be careful and use
common sense.
•
Do not move across obstacles and holes. There is a
higher risk that the product overturns on ground that
is not flat. Look for hidden obstacles in long grass.
•
Do not start or stop on a slope.
Operator
Bystand-
ers
15–50 m
>50 m
5–50 m
>50 m
Read the warning
21
Publicidad
