Husqvarna P 524XR EFI Manual De Usuario página 79

Status of the battery charger
The indicator for the battery status is 2 LEDs on the
battery charger: Battery Power LED (red) and Battery
Status LED (green).
Battery Battery Status
Power LED
LED
Red light OFF
Red light Green light
Remote control
For instructions for the remote control, refer to
control on page 80 .
Transportation
• The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
• Do not lift the product. The transport eyelets are
not approved lifting points and must only be used
to attach the product safely to a trailer.
• Use an approved trailer for transportation of the
product.
• Make sure that you have knowledge of local
road traffic regulations before transportation of the
product in a trailer or on roads.
To safely attach the product on a trailer for
transport
Before you attach the product, you must read and
understand the safety chapter. Refer to
13 .
WARNING:
not sufficient to lock the product during
transport. Attach the product tightly to the
load area.
Equipment: 4 approved straps and 4 wheel chocks.
1. Park the product in the center of the load area.
1929 - 003 - 05.12.2023
Indication
The charger is ON. No
battery in the charger.
The charger is ON. The
battery is fully charged.
Transportation, storage and disposal
Remote
Safety on page
The parking brake is
Battery Battery Status
Power LED
LED
Red light Green light
flashes
Red light OFF
flashes
Red light Green light
flashes flashes
WARNING:
transport vehicles with a cover. Make
sure that the product is cool before you
put the product in the transport vehicle.
2. Make sure that the center of gravity of the product
is above the wheel axle of the transport vehicle. If a
trailer is used for transport, make sure that the down
force on the tow bar is correct.
3. Apply the parking brake.
4. Lower the cutting deck to the float position.
5. Remove all loose objects.
6. Put the first strap through the rear transmission
frame.
7. Put the second strap through the rear transmission
frame.
8. Attach the straps to the load area.
Indication
The charger is ON. The
battery charges.
Error on the battery charg-
er, or temperature out of
the charging range.
The battery does not
charge because of too
high or low temperature.
For transport in
79