en - Installation notes
Water connection
for variants with
reduced heater
rating (RH)
Water connection
for variants with
external heating
(EH)
32
There are the following options for draining the machine:
- Drain hose connected to a plastic drain pipe with a rubber sleeve
(there is no need to use a siphon)
- Drain hose connected securely to a sink with a plastic nipple
- Connected securely to a floor drain (gully)
If required, the hose can be extended to a length of up to 5 m. The
corresponding accessories are available from the Miele Customer
Service Department or your Miele dealer.
For a drain height of more than 1 m, a replacement drain pump for a
delivery head of max. 1.8 m is available from the Miele Customer Ser-
vice Department or from your Miele dealer.
The appliance should be connected to cold and hot water supplies. A
minimum hot water temperature of 80 °C is recommended in order to
use all programmes. Lower temperatures may result in longer pro-
gramme running times or cause programmes to be interrupted. Water
inlet temperatures below 60 °C are not permitted, as they can lead to
significantly longer programme running times.
The appliance should be connected to cold and hot water supplies. A
minimum hot water temperature of 80 °C is recommended. The use
of disinfection programmes is not possible due to the absence of ad-
ditional heating. The permissible wash temperatures are determined
by the inlet temperature.
Dispenser connection
The machine is equipped with an interface for external dispenser sys-
tems. Adapters for pre-mixed suds or liquid detergent from external
dispenser systems for up to 6 connections should be obtained from
the Miele Customer Service Department and connected.
A separate Connector Box is required for controlling the dispensing
pumps electrically. This must be installed by your Miele dealer or
the Miele Customer Service Department. It is particularly important
to follow the manufacturer's instructions when using a combination
of cleaning agents and special application products.