Publicidad
WARNING: THIS PRODUCT MUST ONLY BE
OPERATED IN AN UPRIGHT POSITION.
CAUTION: DUE TO THE HIGH RATED POWER, DO
NOT PLUG INTO AN EXTENSION LEAD.
• Do not use this heater if it has been dropped.
• Do not use if there are visible signs of damage to the heater.
• Do not use this appliance in a dusty environment, especially in
workshop area (sawdust, plaster dust, etc.)
Plug Replacement
This appliance is supplied with a BS 1363 3 pin plug fitted with a 10Amp fuse. Should the fuse require
replacement, it must be replaced with a fuse rated at 10mp and approved to BS 1362.
In the event the mains plug has to be removed/ replaced for any reason, please note:
IMPOTRANT: THE WIRES IN THE MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE;
Blue - Neutral
Brown - Live
As the colors of the wires in the mains of this applicance may not correspond with the coloured marking
identifying with the terminals in your plug, proceed as follows.
The blue wire must be connected to the terminal marked with an N or coloured black.
The brown wire must be connected to the terminal marked with an L of coloured red.
WARNING: NEVER CONNECT LIVE OR NEUTRAL WIRES TO THE EARTH
TERMINAL OF THE PLUG.
BLUE
Neutral
Cord Clamp
BROWN
Live
FUSE
10 Amps
5
Publicidad
