Hama RC 650 Instrucciones De Uso página 3

5. Operation
5.1. Automatic time setting using the DCF signal
* Once you have removed the contact breaker, an acoustic signal sounds and the
alarm clock automatically starts searching for a DCF signal. During the search, the
radio icon ® (2) will flash.
After 5-10 minutes (depending on how quickly the radio signal is received), the
clock sets itself to the correct time.
When the wireless signal is received, the date, time, weekday and temperature are
automatically set and the radio icon (2) is displayed
If the clock is unable to receive a time signal wirelessly, the time/weekday/
temperature are displayed and the radio icon Ÿ (2) is not visible. In this case, you
can set the time manually.
Active
Successful — signal is being received
Deactivated
5.2. Manual setting
Manually setting the date/time/calendar
* Press and hold the Down (10) button for approx. 3 seconds to stop the search for
the DCF signal. The radio icon (2) goes out and you can set the time manually.
+ Press and hold the SET button (9) for approx. 3 seconds to start manually setting
the date/time.
Set the following information in the order listed:
To select the individual values, press the UP (8) button or the Down (10) button
and confirm each selection by pressing the SET button (9).
+ After setting the date, you will be able to select the language in which the weekday
will be displayed. You can choose between the following languages:
GER for German, ENG for English, FRA for French, ITA for Italian, NET for Dutch, ESP
for Spanish, DAN for Danish
The clock automatically switches to summer time. $ appears on the display as long
as summer time is activated.
Note — Time zone
+ The time zone is used if the DCF time signal is received in a country whose time
zone does not correspond to German time
+ Ifthe time shift is +1 hour, for example, you need to set the time zone to +1. This
will automatically set the clock forward one hour.
5.3. Setting the alarm
Setting Alarm 1
Press the AL1 (7) button. The bell icon appears.
Press the AL1 (7) button for approx. 3 seconds until the hour digits start flashing
You can set the hours with the UP (8) and DOWN (10) buttons
Press the SET (9) button until the minutes digits start flashing. You can set the
minutes with the UP (8) and DOWN (10) buttons.
* Press the SET (9) button to save the set alarm time.
Setting Alarm 2
Press the AL2 (11) button. The (bell) icon appears.
Press the AL2 (11) button for approx. 3 seconds until the hour digits start flashing
You can set the hours with the UP (8) and DOWN (10) buttons.
Press the SET (9) button until the minutes digits start flashing. You can set the
minutes with the UP (8) and DOWN (10) buttons.
Press the SET (9) button to save the set alarm time
Activating Alarm 1/Alarm 2:
+ Press AL 1 to activate Alarm 1. The bell icon appears above the time
+ Press AL 2 to activate Alarm 2. The bell icon appears below the time
* Alarm 1 and Alarm 2 can both be activated at the same time
00136203 05man de el en es fr it nl pl ru.indd 5-6
e
24.10.14 08:44