Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Battery High-temperature Protection
If the battery temperature exceeds 70°C during operation,
the temperature-protection circuit will immediately
shut off the machine to protect the battery pack from
overheating damage. The battery-status indicator will
glow solid orange. Release the trigger and wait until the
overheated battery cools down and the indicator turns
green, then restart the machine.
Battery Electronics Error Protection
When the battery pack electronics error occurs, the
battery-status indictor will flash red/green alternately
and the machine will shut off in 3 seconds. Replace the
battery pack or contact EGO customer service center.
Machine Overload Protection
This machine has built-in overload circuit protection.
When the machine is overloaded, the motor will stop
and the speed indicator will flash orange. Remove the
battery pack from the machine, then reattach the battery
pack and restart the machine. Decrease the load on the
machine, avoid too long or oversize cutting line or cutting
on the heavy/woody shrubs.
Machine High-temperature Protection
If the machine temperature exceeds 90°C during
operation, the temperature-protection circuit will
immediately shut off the machine from overheating
damage. The speed indicator will glow solid orange.
Release the trigger and wait until the overheated machine
cools down and the speed indicator turns green, then
restart the machine.
COMMUNICATION TECHNOLOGY
For information on our full range of connected products
and services, including connection instructions, please
scan the QR Code below or visit
www.egopowerplus.eu/connect.
USING THE HEDGE TRIMMER
WARNING:
Avoid trimming too much at one time or
through the heavy shrubbery. This can cause the blades to
bind and slow, reducing the cutting efficiency.
12
56 VOLT LITHIUM-ION CORDLESS ARTICULATING POLE HEDGE TRIMMER— HTX5300-PA
WARNING:
To prevent serious personal injury, keep
hands away from blades. Do not attempt to remove cut
material or hold material to be cut when the blades are
moving. Make sure that the blades have completely
stopped and the battery pack is removed before clearing
jammed material from blades. Do not grasp the exposed
cutting blades or cutting edges when picking up or
.
holding the unit
WARNING:
Clear the area to be cut before each use.
Remove all objects, such as cords, lights, wire, or string
which can become entangled in the cutting blade and
create a risk of serious personal injury.
NOTICE:
For new growth, a wide sweeping is suitable
for the stems fed directly into the cutting blade. For older
growth, a sawing movement is good for trimming the
thicker stems. A non-powered hand saw or pruning saw is
suggested for trimming the large stems first.
Cutting Close to the Ground
1. Set the cutting blades to a suitable angle.
2. Swing the hedge trimmer right and left in an arc and
do not rest the cutter blade on the ground (Fig. L).
Cutting the Side of the Hedge (Fig. M1, M2)
1. Set the cutting blades to a suitable angle.
2. Slowly swing the hedge trimmer up and down in an
arc as you move along the hedge.
Cutting the Top of the Hedge (Fig. N)
1. Hold the cutting blades at an angle of 0° to 10° to the
top of the hedge.
2. Swing the hedge trimmer horizontally and in an arc
while making the cut.
Cutting Overhead (Fig. P1, P2)
1. Set the cutting blades completely to a suitable angle.
2. Hold the hedge trimmer and slowly swing it in an arc
to make maximum use of its reach.
WARNING:
Any overhead working position is tiring.
To minimize the risk of accidents, work in such positions
for short periods only. Set the angle of the blades to
maximum so that the machine can be held in a lower, less
tiring position while still providing adequate reach.
Publicidad
