Publicidad
Idiomas disponibles
Idiomas disponibles
9. E-gear button. Refer to
on page 14 .
10. E-gear 2 indicator
11. E-gear 1 indicator
Automatic OFF function
The product has an automatic OFF function that sets the
product to OFF if you do not operate it for 3 minutes.
Start/stop button
The start/stop button is used to start and stop the drill
motor.
To do a check of the start/stop button
1. Install the battery and push the On/Off button. Refer
to
To start the product on page 14 .
2. Push the start/stop button to start the drill operation.
3. Push the start/stop button again to stop the drill
operation.
Friction clutch
The friction clutch is integrated in the gearbox of the
product. It prevents damage to the product in the event
of a sudden stop of the spindle shaft.
CAUTION:
time of the clutch is not more than 3-4
seconds, because if not wear and heat will
increase quickly.
Safety instructions for maintenance
WARNING:
instructions that follow before you do
maintenance on the product.
•
Remove the battery before you do maintenance,
other checks or assemble the product.
•
The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
10
To use the E-gear function
Make sure that the release
Read the warning
•
Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
•
If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
•
Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
•
Only use original spare parts.
Always use common sense
WARNING:
should you modify the original design of
the product without approval from the
manufacturer. Always use original spare
parts. Unauthorized modifications and/or
accessories may lead to serious injury or
death to the user or others.
WARNING:
as cutters, grinders, drills, that sand or form
material can generate dust and vapours
which may contain hazardous chemicals.
Check the nature of the material you intend
to process and use an appropriate breathing
mask.
It is not possible to cover every conceivable situation
you can face when using the product. Always exercise
care and use your common sense. Avoid all situations
which you consider to be beyond your capability. If
you still feel uncertain about operating procedures after
reading these instructions, you should consult an expert
before continuing.
Do not hesitate to contact your Husqvarna
representative if you have any more questions about the
use of the product. We will willingly be of service and
provide you with advice as well as help you to use your
product both efficiently and safely.
Let your Husqvarna dealer check the product regularly
and make essential adjustments and repairs.
Husqvarna Construction Products has a policy of
continuous product development. Husqvarna reserves
the right to modify the design and appearance of
products without prior notice and without further
obligation introduce design modifications.
All information and all data in the operator's manual
were applicable at the time the operator's manual was
sent to print.
Under no circumstances
The use of products such
1941 - 005 - 25.09.2023
Publicidad
