Descargar Imprimir esta página

Husqvarna DM1 PACE Manual De Usuario página 11

Ocultar thumbs Ver también para DM1 PACE:

Publicidad

Idiomas disponibles

Idiomas disponibles

®
Bluetooth
CAUTION:
made to this equipment not expressly
approved by Husqvarna may void the FCC
authorization to operate this equipment.
Notice: This device complies with Part 15 of FCC
Rules and with Industry Canada licence-exempt RSS
standard. Operation is subject to the following two
conditions:
This device may not cause harmful interference
Introduction
WARNING:
product, read the safety chapter.
WARNING:
during assembly, disconnect the battery
from the product.
Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
1. Read the operator's manual for the drill motor
carefully and make sure that you understand the
instructions.
2. Read the operator's manual for the drill stand
carefully and make sure that you understand the
instructions.
3. Do the daily maintenance. Refer to
schedule on page 18 .
4. Use personal protective equipment. Refer to
Personal protective equipment on page 9 .
5. Make sure that the work area is clean and bright.
1941 - 005 - 25.09.2023
Changes or modifications
Assembly
Before you assemble the
To prevent accidental start
Operation
Read and understand the
Maintenance
This device must accept any interference received,
including interference that cause undesired
operation.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions
suivantes:
l'appareil ne doit pas produire de brouillage, et
l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
To attach the product to a drill stand
CAUTION:
for the drill stand carefully.
To attach the product to a drill stand, refer to the
manual for the drill stand.
Use only with approved Husqvarna drill stands.
6. Make sure that the product is installed correctly. The
drill bit and the drill stand must be attached correctly.
Read the operator's manual
11

Publicidad

loading