Publicidad
Idiomas disponibles
Idiomas disponibles
5. Align the screw hole in the leg with the hole in the leg
socket. Then secure with screw and tighten. DO NOT
OVER TIGHTEN. Repeat this until all 6 legs are securely
attached to the top rail frame with screws.
6. After attaching all 6 of the legs securely to the top rail
frame, turn the frame over so that the legs point down-
ward, as shown.
7. To ensure that the enclosure mesh connectors will be
properly aligned with the enclosure poles, hold up the
mesh by one of the nylon patches with grommet and se-
lect the nylon loop sewn onto the jump mat that is directly
beneath the nylon patch you are holding. The patch at
the top, the upper and lower hook & loop fasteners, and
the nylon loop on the mat will all be along the sample line
(shown in white). This nylon loop (sewn to the mat) will
be the
on you attach, and MUST be attached to the
frame right next to one of the 6 enclosure pole sockets.
GB
7
A083a Revised 140cm Trampoline IM & add Spanish_20120807.indd 7
7/8/2012 16:04:13
Publicidad
