Publicidad
Idiomas disponibles
Idiomas disponibles
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.
12. Environmental Protection
The generated grinding dust may contain harmful
substances. Dispose appropriately.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
13. Technical Specifications
Explanatory notes on the specifications on page 4.
Changes due to technological progress reserved.
Ø
= max. diameter of the accessory
t
= max. permitted thickness of the
max,1
clamping shank on accessory when
using 2-hole nut (13)
t
= max. permitted thickness of clamping
max,2
shank on accessory when using
"Quick" clamping nut (1)
t
= roughing disc/cutting disc:
max,3
max. permitted thickness of accessory
M
= spindle thread
l
= length of the grinding spindle
n*
= no-load speed (maximum speed)
n
*
= no-load speed (adjustable)
V
I
= Current at 120 V
120 V
m
= weight without mains cable
* Machines with the designation WE... : Energy-rich,
high-frequency interference can cause fluctuations
in speed. The fluctuations disappear, however, as
soon as the interference fades away.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. Depending on the operating
conditions, the condition of the power tool or the
accessories, the actual load may be higher or lower.
For assessment purposes, please allow for breaks
and periods when the load is lower. Based on the
adjusted estimates, arrange protective measures
for the user e.g. organisational measures.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a
= Vibration emission value
h, SG
(surface grinding)
a
= Vibration emission value
h, DS
(sanding with sanding plate)
a
= Vibration emission value
h, P
(polishing)
K
= Uncertainty (vibration)
h,SG/DS/P
Wear ear protectors!
ENGLISH en
15
Publicidad
