SOMFY RDO 50 CSI Manual De Instalación página 9

RDO 50 CSI / RDO 60 CSI
> Cable feed
If the motor is to be used outdoors, the PVC power supply
cable [VVF, 60227 (IEC)] must be installed in a duct (under
a tray).
1.4 Safety instructions relating to installation
which is not required for motorised operation.
connection components between the transmission and
the door shaft accidentally ruptures. Use a fall protection
an additional element not recommended in this manual is
strictly prohibited.
Install the operating element less than 1.80 m from the
ground.
door.
Fasten the label concerning crushing and the manual
works correctly.
> Clothing precautions
Take off any jewellery (bracelet, chain, etc.) during
installation.
protection, etc.).
1.5 Safety instructions relating to use
garage door.
1.6 Regulations
Somfy declares that the product described in these
instructions, when used in accordance with these
instructions, complies with the essential requirements of
Geoffroy, Head of Regulations, Cluses
Somfy limited, Yeadon LS19 7ZA UK hereby
used as intended according to these instructions,
is in compliance with UK legislation of Machinery safety
regulations S.I.2008 N°1597. The full text of the UKCA
WARNING
DANGER
WARNING
& Ireland, Yeadon, 10/2021.
2 - FIELD OF APPLICATION
3 - INSTALLATION
3.1 Preparing the tube - Fig.1
3.2 Assembling the motor - Fig. 2
3.3 Installing the tube on its brackets - Fig.3
3.4 Manual operation - Fig.4
4 - POWER SUPPLY AND WIRING
-
5 - SETTING THE END LIMITS
5.1 Setting the upper end limit - Fig. 5
5.2 Setting the lower end limit - Fig. 6
6 - TROUBLESHOOTING
6.1 The motor does not work
- the motor wiring
- the thermal contact (wait for the motor to cool down)
- the conformity of the cable used (4 conductors)
6.2 The device stops too early
- the operation of the end limits while the motor is rotating
-
-
7 - TECHNICAL DATA - FIG. 7
2