Publicidad
Idiomas disponibles
Idiomas disponibles
Using Your Oven
:,:
i
: ,:::
:
,:i _,
Before Using Your Oven
Be sure you understand
how to set the control proper-
ly. Practice
removing
and replacing
the shelves
while
the oven is cool. Read the information
and tips on the
following
pages.
Keep this manual
handy where
you
can refer to it, especially
during
the first weeks
of
using your new range.
Lighting instructions
for
Standing Pilot ModeUs
Some models
have standing
oven pilots that must be
lit initially.
To light the oven
pilot:
1. Be sure the OVEN
CONTROL
knob is in the OFF
position.
2. Open the broiler drawer
and remove the broiler pan
and rack. This will make it easier
for you to reach
inside the broiler compartment.
3. Find the oven
pilot port at the back of the broiler
compartment.
The long tube, running
from front to
back,
is the oven
burner.
The pilot port is at the
back, about one inch below the burner.
4, Using a long match
or match
holder,
reach in and
light the oven pilot.
,,To light
the
oven
burner,
turn the OVEN
CON-
TROL
knob to the desired
temperature.
The burner
should light within 60 seconds.
o Proper
flame
configuration,
while
using the oven
burner, visually
check the burner flame in the broiler
compartment.
If flame does not burn as described
in
the Installation
section
of this manual,
adjust
the
flame following
the directions
on those pages.
o Power
failure:
An electrical
power
failure
will not
affect a lighted standing
oven pilot.
Lighting Hnstructions for
Electric ignition Models
The oven
burner
is lighted
by electric
some
models).
_
::
To light the burner,
turn the OVEN CONTROL
!
to the desired
temperature.
The burner
should ignite:_i:i:i i :ii,:iii i
within 30-90 seconds.
:
.... i
After
the oven
reaches
the seiected
temperaiu:_ei:
oven burner cycles--off
completelyl therl on with a full: i::i:i
flame--to
keep
the
oven temperature
€ont!olledi :i
Power
Outage
CAUTION:
Do not make any attempt tO operate the
electric
ignition oven during an electrical
powerfail_
ure. The oven or broiler cannot be lit during a p(
failure.
Gas will not flow unless the glow bar is
If the oven is in use when a power failure
ocCurSi
the oven burner shuts Off and cannot be re-lit Until
power is restored.
Oven ControU
The OVEN CONTROL
knob is
located on the control panel on
/.
the front
of the range.
Simply
turn
the
knob
to the
desired
cooking temperatures.
tt will normally
take 30-90 sec-
onds
before
the flame
comes
k_
on. After the oven reaches
the
selected
temperature,
the oven
burner
cycles--off
completely,
then
on with
a full flame--to
maintain
the selected
tempera-
ture.
•i•••!• :•:/••
• _:••i_•••/•
•
Oven Light (onsomemodels)
Use the switch on the control
panel to turn the oven
light on and off.
!0
Publicidad
