Tabla de contenido
Publicidad
THE PRODUCT. AVOID PLACING THE
CHILD NEAR SAFETY HAZARDS SUCH
AS ELECTRICAL CORDS, SOURCES OF
HEAT, OR FLAMES.
_ DO NOT USE THE PRODUCT NEAR
STAIRS OR STEPS.
_ BE CAREFUL NOT TO PLACE THE
PRODUCT NEAR SOURCES OF HEAT
OR FLAMES, SUCH AS GAS STOVES,
ELECTRIC HEATERS, ETC.
_ MAKE SURE THE BELT IS ATTACHED
PROPERLY.
_ DO NOT USE THE HIGH CHAIR
UNLESS ALL OF THE PARTS ARE
PROPERLY FITTED AND ADJUSTED.
_ TO MAKE SURE THAT ANY HARNESS
IS CORRECTLY FITTED
NOTICE:
_ THIS ARTICLE MEETS OR EXCEEDS
ALL REQUIREMENTS COVERED IN EN
14988 AND ASTM F404 STANDARD
AND LATEST REVISIONS.
WEEE DIRECTIVE (EU ONLY)
_ AT THE END OF ITS USEFUL LIFE, THIS
PRODUCT IS CLASSED AS WASTE
ELECTRICAL AND ELECTRONIC
EQUIPMENT (WEEE) AND MUST
THEREFORE NOT BE DISPOSED OF
AS URBAN WASTE BUT INSTEAD
MUST BE TAKEN TO A DESIGNATED
SEPARATED WASTE COLLECTION
FACILITY.
_ TAKE THE REFUSE TO THE RELEVANT
DESIGNATED COLLECTION FACILITY.
_ THE PRESENCE OF DANGEROUS
SUBSTANCES CONTAINED IN THE
ELECTRICAL COMPONENTS OF
THIS PRODUCT REPRESENTS A
POTENTIAL SOURCE OF DANGER
FOR HUMAN HEALTH AND FOR THE
ENVIRONMENT IF THE PRODUCT IS
NOT CORRECTLY DISPOSED OF.
_ THE BARRED DUSTBIN INDICATES
THAT THE PRODUCT MUST BE
SUBJECT TO SORTED WASTE
COLLECTION.
COMPONENTS OF THE ITEM
Check the contents of the packaging and if you
have any complaints please contact the Assistance
Service.
_ Washable, removable liner, play bar.
INSTRUCTIONS FOR USE
1 COVER: Place it over the upholstery of the seat
(fig_a) and pass the ends of the safety harness
through the slots in the cover (fig_b).
2 Button down the cover on the sides (fig_c). Figure
D shows the cover in place.
PLAY BAR: Insert the ends of the play bar into the
same slots that are used for fitting the tray.
3 When the seat is fully reclined, incline the play
bar towards the child when you insert it, as in the
figure.
4 When the seat is in the upright position, insert the
play bar as in the figure.
5 The cow on the play bar produces sound effects.
Press its feet to hear them.
CLEANING AND MAINTENANCE
PRODUCT MAINTENANCE: protect from the
weather: water, rain, or snow; prolonged and
continuous exposure to bright sunlight may
give rise to colour changes of various different
materials; store this product in a dry place.
CLEANING FABRIC PARTS: brush fabric parts to
remove dust and wash by hand at a maximum
temperature of 30°C; do not wring; do not use
chlorine bleach, do not iron; do not dry clean; do
not apply solvent-based stain removers and do
not dry in a tumble dryer.
PEG-PÉREGO S.p.A.
working methods.
Peg Pérego can make changes at any time to the
models described in this publication for technical
or commercial reasons.
Peg Pérego is at the disposal of its customers
and consumers to ensure that all their demands
and queries are fully satisfied. It is a key part of
our policy to ensure we are always aware of our
customers' views and requirements. We would
therefore be very grateful if, after using a Peg
Pérego product, you take the time to fill in our
CUSTOMER SATISFACTION QUESTIONNAIRE,
making a note of any comments or suggestions
you might have. You can find the questionnaire on
the Peg Pérego website: www.pegperego.com
PEG-PÉREGO AFTER-SALES SERVICE
If any parts of your Peg Pérego product should be
accidentally mislaid or damaged, use exclusively
genuine original Peg Pérego replacements. For
any repairs, replacements, product information,
and orders for genuine original replacement parts
and accessories, contact Peg Pérego After-Sales
Service:
tel. 0039/039/60.88.213
e-mail assistenza@pegperego.it
pegperego.com
- 7 -
Peg-Pérego S.p.A. is an ISO 9001
certified company. This
certification is a guarantee for
customers and consumers of the
transparency and trustworthiness
of the company's procedures and
fax 0039/039/33.09.992
website www.
Publicidad
Tabla de contenido
