Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY AND INFORMATION SIGNS
The illustration shows the position of the signs pro-
vided.
A)Nameplate with manufacturer and appliance
data.
B)Burn hazard: watch out for hot surfaces.
C)General hazard: when washing the appliance do
not point water at it..
D)General hazard: read the manual carefully before
carrying out any procedure.
E)General hazard: all relevant regulations must be com-
plied with. "Install in compliance with the relevant regu-
lations and use in well ventilated premises only".
F) General hazard: all relevant regulations must be
complied with. "No liability is accepted in case of fail-
ure to comply with the installation and commission-
ing instructions".
G)CE marking: indicates that the appliance is compli-
ant with the relevant norms.
OPTIONAL ACCESSORIES
The appliance can be equipped with the following
accessories on request.
A)Feet
B)Complete kit for appliances installed in banks
SAFETY REGULATIONS
During design and construction, the constructor has
paid special attention to factors which may cause
risks to the health and safety of the people interact-
ing with the appliance. As well as complying with
the relative legal requirements, he has adopted all
the "rules of good construction practice". This infor-
mation is provided to encourage users to take spe-
cial care in order to prevent all risks. However, there
is no replacement for care and attention. Safety
also depends on all the operators who interact with
the appliance.
Read the instructions provided in the manual sup-
plied and those applied to the appliance itself with
C
H)WEEE symbol: indicates that the appliance is sub-
ject to specific waste disposal regulations.
SAFETY
care, paying special attention to those relating to
safety. Taking a little time to read them will prevent
unpleasant accidents; it is always too late to re-
member what should have been done after an acci-
dent has happened.
Never tamper with, elude, eliminate or bypass the
safety devices installed. Failure to comply with this
rule may cause serious risks to health and safety.
Even after you have read all the appropriate docu-
mentation, if necessary on first use carry out a few
trial operations to get to know the controls, espe-
cially those used for switching on and off.
- 5 -
D
F
E
A
B
G
A
H
IDM-39613200300.tif
IT
IDM-39612800400.tif
GB
DE
3
FR
ES
English
Publicidad
