Publicidad
Idiomas disponibles
Idiomas disponibles
36" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
9.2
Single Burner
All other burners on the cooktop are single
burners. It comes with 2 piece assembly and
operates with single nozzle.
Installing the single burner
1.
Allign arrow mark on the buner head to the
ignitor and place burner head on the burner
base such that the ribs on the head should sit in
the grooves on the base.
2. Place the burner cap on the burner head. Ensure
the cap is centered and fits snugly on the head.
Figure 17: Single burner Assembly
9.3
Check Ignition on Surface
Burners
Operation of electric igniters should be checked
after range and supply line connectors have been
carefully checked for leaks and range has been
connected to electric power.
To check for proper lighting:
1.
Push in and turn a surface burner knob to the
" " (lite) position. All electronic surface ignitors
will spark at the same time. Only the burner you
are turning on will ignite.
2. The surface burner should light once the flow
of gas reached the surface burner. Each burner
should light within four (4) seconds in normal
operation after air has been purged from supply
lines. Visually check that the burner has lite.
3. Once the burner lights, the control knob should
be rotated out of the " " (lite) position.
Turn on each of the surface burners and check to
see that they light properly and that the flames are
even. Adjust settings if necessary.
Burners
To adjust the low setting of surface burners:
1.
2. Quickly turn knob to lowest position.
3. If burner goes out, reset control to OFF.
4. Remove the surface burner control knob and
5. Insert a thin-bladed screwdriver into the hollow
Burner Cap
6. Adjust flame until you can quickly turn knob
Burner Head
Burner Base
Injector nozzle
Ignition
Spark Plug
NOTES:
•
•
19
9.4
Adjust Low Settings on Surface
Push in and turn control to " " (lite) until burner
ignites.
decorative ring.
valve stem and engage the slotted screw inside.
Flame size can be increased or decreased by
turning the screw.
from the sparking position to the lowest flame
position without extinguishing the flame. Flame
should be as small as possible without going out.
Figure 18: Turn to adjust surface flame
Air mixture adjustment is not required on
surface burners.
Some models have two flames on each burner.
The center flame on these burners is not
adjustable.
Publicidad
