Publicidad
Idiomas disponibles
Idiomas disponibles
36" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
Cabinet Dimensions
Clearances and Dimensions
•
Provide adequate clearances between the appliance and adjacent combustible surfaces.
•
Location - Check location where the appliance will be installed. Check for proper electrical supply and
floor stability.
•
Dimensions shown must be used. Given dimensions provide minimum clearance. Contact surface must
be solid and level.
F. MINIMUM
MODEL
CUTOUT
WIDTH
36"
36" (91.4 cm)
NOTES:
1.
Do not seal the range to the side cabinets.
2. Clearance from adjacent walls or other vertical surfaces or structures such as cabinets.
3. Measurements listed are minimum clearances between the cooktop and the bottom of the cabinet.
4. 0" clearance between range and cabinets or vertical surfaces that are below the cooktop height.
5. 0" clearance between range back and rear wall or cabinet.
*36" (914 mm) minimum clearance between the top of the cooking surface and the bottom of an
unprotected wood or metal cabinet; or 30"(762 mm) minimum when bottom of wood- or metal cabinet
is protected by not less than 1/4"(6mm) flame retardant millboard covered aith not less than no.28 MSG
sheet steel, 0.015"(0.4mm) stainless steel, 0.024"(0.6mm) aluminum or 0.020"(0.5mm) copper. 0"(0mm)
clearance is the minimum for the rear of the range.
Follow all dimension requirement provided above to prevent property damage, potential fire hazard, and
incorrect countertop and cabinet cuts.
I
H
F
G
Figure 2: Cabinet Dimensions
G. HEIGHT OF
COUNTERTOP
36" (91.4 cm)
Standard
35 3/4" (90.8 cm)
Min.
J
18" Min.
(45.7 cm Min.)
I. CLEARNACE
H. CLEARANCE
FROM COOKTOP
FROM SIDE
AND CABINET
WALLS
2
36" (91.4 cm)
5" (12.7 cm) Min.
Min.
6
13" Max.
(33 cm Max.)
24" Min.
(61 cm Min.)
24½" max.
(62.2 cm Max.)
J. CLEARANCE
WIDTH OF
OVERHEAD
BOTTOM
CABINETS
3
36" (91.4 cm) Min.
Publicidad
