Kohler K-2333 Guia De Instalacion página 5

K--2333-0 Only
Bottom Edge of Spout
1" (2.5cm) Min
4. Install the Faucet
CAUTION: Risk of product damage. Do not use plumbers putty
with your marble lavatory. Plumbers putty can cause permanent
discoloration of marble surfaces.
When Installing the Faucet for the K-2333-0
- Install the faucet to the wall according to the manufacturer's
instructions.
- Ensure that there is enough clearance for hand washing.
- Make sure the faucet has a minimum of 1" (2.5cm) clearance over
the rim of the lavatory.
- Direct the stream of water toward the center of the lavatory.
When Installing the Faucet for the K-2333-1
- Install the faucet to the faucet deck on the lavatory according to the
faucet manufacturer's instructions.
NOTE: If employing the K- 7702 pop- up drain with this installation, it
may be necessary to drill an additional mounting hole in the connecting
link using a 5/16" drill bit. If needed reference the pop- up drain
installation instructions for part descriptions.
5. Attach the Threaded Studs
- Using a marker, mark a spot 1/2" (1.3cm) from one end of each of
the four provided 70mm threaded studs.
- Screw the marked end of each stud into an insert on the bottom of
the lavatory. Do not screw the studs past the previously made mark.
Kohler Co.
Stud
Mark Here
5
1/2" (1.3cm)
B
1023121-2-