Select Attenuation (Fil); Restore Factory Settings (Reset) - Seca 704 Manual De Uso

Select attenuation (Fil)

Restore factory settings
1. Select the item "BEEP" in the menu.
2. Confirm the selection.
3. Select a menu item:
4. Confirm your selection.
The current selection is displayed.
5. Select the setting you require:
6. Confirm your selection.
You will leave the menu automatically.
7. If you also wish to activate the acoustic signal for
the second function, repeat this procedure.
You can use attenuation (Fil = filter) to reduce any
interference during weighing (e.g. caused by patient
moving).
1. Select the item "Fil" in the menu.
2. Confirm the selection.
The current selection is displayed.
3. Select an attenuation level.
4. Confirm the selection.
You will leave the menu automatically.
You can restore the factory settings for the following
(RESET) functions:
Autohold (Ahold)
Acoustic signal (Press)
Acoustic signal (Hold)
Attenuation (Fil)
NOTE:
The function "Acoustic signal with stable weigh-
ing value" is activated at the factory. If required,
you can disable this function.
– Press: Acoustic signal whenever a key is
pressed
– Hold: Acoustic signal with a stable weighing
value.
– On
– Off
– 0: low attenuation
– 1: moderate attenuation
– 2: high attenuation
Function
English
Factory setting
depending on
model
off
on
0
Operation • 55