Zanussi ZITN323K Manual De Instrucciones página 46

of the front left zone to choose one of the
following:
• - the sounds are off
• - the sounds are on
To confirm your selection wait until the hob
deactivates automatically.
When the function is set to
the sounds only when:
• you touch
• Minute Minder comes down
• Count Down Timer comes down
• you put something on the control panel.
5.12 Power management
If multiple zones are active and the
consumed power exceeds the limitation of the
power supply, this function divides the
available power between all cooking zones
(connected to the same phase). The hob
6. HINTS AND TIPS
WARNING!
Refer to Safety chapters.
6.1 Cookware
For induction cooking zones a strong
electro-magnetic field creates the heat in
the cookware very quickly.
Use the induction cooking zones with suitable
cookware.
• The bottom of the cookware must be as
thick and flat as possible.
• Ensure pan bases are clean and dry
before placing on the hob surface.
• In order to avoid scratches, do not slide or
rub the pot across the ceramic glass.
Cookware material
• correct: cast iron, steel, enamelled steel,
stainless steel, multi-layer bottom (with a
correct marking from a manufacturer).
• not correct: aluminium, copper, brass,
glass, ceramic, porcelain.
46 ENGLISH
controls heat settings to protect the fuses of
the house installation.
• If the hob reaches the limit of maximum
• The heat setting of the cooking zone
you can hear
• The heat setting display of the reduced
• Wait until the display stops flashing or
Cookware is suitable for an induction hob
if:
• water boils very quickly on a zone set to
• a magnet pulls on to the bottom of the
Cookware dimensions
• Induction cooking zones adapt to the
• The cooking zone efficiency is related to
• For both safety reasons and optimal
Refer to "Technical data".
available power (refer to the rating plate),
the power of the cooking zones will be
automatically reduced.
selected last is always prioritised. The
remaining power will be divided between
the previously activated cooking zones in
reverse order of selection.
zones changes between the initially
selected heat setting and the reduced heat
setting.
reduce the heat setting of the cooking
zone selected last. The cooking zones will
continue operating with the reduced heat
setting. Change the heat settings of the
cooking zones manually, if necessary.
the highest heat setting.
cookware.
dimension of the bottom of the cookware
automatically.
the diameter of the cookware. The
cookware with a diameter smaller than the
minimum receives only a part of the power
generated by the cooking zone.
cooking results, do not use cookware
larger than indicated in "Cooking zones
specification". Avoid keeping cookware
close to the control panel during the
cooking session. This might impact the
functioning of the control panel or
accidentally activate hob functions.