Publicidad
• Remove the heater from all packaging and place it in desired location.
• Ensure there is a safe area between the heater and furniture, curtains, etc.
(50 cm safe area from the top and sides and 120 cm safe area in front).
• Unwind the power cord and plug it into the power outlet.
• To activate the heater, turn the knob clockwise to the position for cool
air.
• Turn the knob to "1" for medium power or keep turning to position "2"
for maximum power.
The heater has a built-in safety device, which will switch the heater OFF in case of accidental
overheating. To reset the heater, follow these steps:
1. Turn the control setting to the 'O' position.
2. Unplug the heater and wait 5–10 minutes for the unit to cool down.
3. After the unit has cooled, plug it in and operate normally.
4. Turn rotary switch into desired position (Fan, Low or High).
5. Turn the thermostat switch to the desired temperature position.
6. When the room temperature is comfortable, slowly turn the thermostat switch anticlock-
wise to the minimum position until the appliance switches off.
7. The thermostat switch will keep the room at the desired temperature automatically.
You can also turn the thermostat switch anticlockwise to the minimum position or turn the thermo-
stat switch clockwise to the maximum position to decrease or increase the temperature.
This heater is equipped with a safety tip-over switch, which automatically shuts off the heater
element if it is not in the upright position. The heater will resume as normal when it is returned
to the upright position.
• Be sure to switch off power supply and pull out the plug before cleaning.
• Wait for the heater to cool down sufficiently.
• Clean the body of the heater with a damp cloth. DO NOT ALLOW water into the appliance.
• DO NOT use soap or chemicals which may damage the housing of the heater.
• Allow sufficient drying time before operating again.
• Clean the air inlets and outlets regularly with a vacuum cleaner (at least twice a year for
regular use).
• When the unit is not in use, we recommend placing the heater in its original packaging and
storing in a cool, dry place.
E NGL I SH
8
OPERATING INSTRUCTIONS
AUTO SAFETY SHUT OFF
ANTI-TILT SWITCH PROTECTOR
CLEANING AND MAINTENANCE
Publicidad
