Publicidad
Idiomas disponibles
Idiomas disponibles
6.4 Making cuts
Caution!
For exact, straight and long cuts, we recommend
using a saw blade with a thickness of at least
⁄
".
1
16
•
Make sure that the On/Off switch (3) is not
depressed. Only then should you connect the
battery pack to the equipment.
•
Do not switch on the jigsaw until you have
fitted a saw blade.
•
Only use saw blades that are in perfect
condition. Replace blunt, bent or cracked saw
blades immediately.
•
Place the soleplate flat on the workpiece you
want to saw. Switch on the jigsaw.
•
Allow the saw blade to accelerate until it
reaches full speed. Then slowly move the
saw blade along the cut line. Exert only gentle
pressure on the saw blade as you do so.
•
When cutting metal, apply a suitable coolant
along the line you want to cut.
6.5 Sawing out sections (Fig. 18)
Drill a 0.4'' hole in the section you want to saw out.
Insert the saw blade into this hole and start to saw
out the required section.
6.6 Making parallel cuts (Figure 19)
•
Mount the edge guide and adjust as required
(see section 5.3).
•
Observe the instructions in section 6.3.
•
Cut as shown in Fig. 19.
6.7 Miter cuts (Fig. 9)
•
Set the angle on the soleplate (see section
5.4).
•
Observe the instructions in section 6.3.
•
Cut as shown in Fig. 9.
6.8 LED lamp (Fig. 2/Item 4)
The LED lamp (4) can be used in poor lighting
conditions to additionally illuminate the cutting
position. The LED light (4) will come on
automatically as soon as you press the On/Off
switch (3).
6.9 Charging the Lithium-Ion battery (not
included)
The corresponding instructions can be found
in the original operating instructions for your
charger.
Anl_TP_JST_18_135_Li_BL_SPK7_USA.indb 15
Anl_TP_JST_18_135_Li_BL_SPK7_USA.indb 15
EN
6.10 Battery capacity indicator (Fig. 15 / item
20)
Press the battery capacity indicator switch (21).
The battery capacity indicator (20) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temperature for a day. If the error occurs again,
this means that the battery has been completely
depth-discharged and is defective. Remove the
battery from the device. Never use or charge a
defective battery.
7. Cleaning and maintenance
HAZARD!
Always take the battery out of the equipment
before starting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The ingress of
water into an electric power tool increases the
risk of an electric shock.
7.2 Maintenance
There are no other parts inside the equipment
which require maintenance.
- 15 -
08.12.2023 11:40:13
08.12.2023 11:40:13
Publicidad
