Titan CAPSPRAY X 80 Instrucciones De Uso página 12

TROUBLESHOOTING
10
TROUBLESHOOTING
PROBLEM
The unit will not start
No coating material emerges
from the nozzle
Coating material drips from the
nozzle
Atomization too coarse
Spray jet pulsates
Coating material causes "paint
tears
Excessive paint mist (overspray)
Paint in the air tube
12
CAUSE
•
No power
•
Device overheated
•
Nozzle clogged
•
Material volume setting too low
•
Paint container seal damaged
•
No pressure build-up in container
•
Container empty
•
Air tube loose/damaged
•
Feed tube loose
•
Feed tube / feed tube filter clogged
•
Air vent on feed tube blocked
•
Check valve stuck
•
Air cap, nozzle or needle soiled
•
Nozzle worn
•
Needle worn or damaged
•
Material volume too large
•
Nozzle contaminated
•
Viscosity of coating material too high
•
Too little pressure build-up in
container
•
Air filter heavily soiled
•
Amount of air too low
•
Air hose damaged
•
Coating material in container running
out
•
Air filter heavily soiled
•
Feed tube loose
•
Feed tube / feed tube filter clogged
•
Too much coating material applied
•
Distance too small
•
Incorrect spray nozzle set
•
Distance to the object too large
•
Too much coating material applied
•
Amount of air too high
•
Coating substance over-diluted
•
Incorrect projector set
•
Check valve soiled
•
Check valve defective
SOLUTION
•
Check
•
Unplug the power plug, let the device cool down
approx. 30 minutes, do not bend the hose, check
the air filter, do not cover the intake slots
•
Clean
•
Increase volume
•
Replace
•
Tighten container
•
Refill
•
Insert or replace
•
Insert
•
Clean or use another filter
•
Clean
•
Remove and clean (see section 8.3)
•
Clean
•
Change
•
Replace the needle (see section 3.1)
•
Reduce volume
•
Clean
•
Dilute further
•
Tighten container
•
Change (see section 8.1)
•
Increase volume
•
Check and replace if necessary
•
Refill
•
Change (see section 8.1)
•
Insert
•
Clean or use another filter
•
Reduce volume
•
Increase distance
•
Use a different spray nozzle set
•
Reduce distance
•
Reduce volume
•
Reduce volume
•
Reduce degree of dilution
•
Use a different projector set
•
Clean the check valve (see section 8.3)
•
Replace the check valve (see section 8.3)
CAPSPRAY X 80