Publicidad
Idiomas disponibles
Idiomas disponibles
Adjust the Floor Removal Cart
to Install the Block Clamps and
Breaker Hammer
(Fig. 4)
1. Adjust the Floor Removal Cart to the lowest
position by squeezing the Height Adjustment
Lever 6 then pushing the handle downward.
Release the Height Adjustment Lever 6 once
the locking pin is in the last hole.
2. Rest the end of the Cart Frame 11 onto an
object suitable to hold its weight, so that
the frame is close to level as possible.
Attach the Clamping Blocks
(Fig. 5)
1. Install two Clamping Block Rods 14 into a
Top Clamping Block 12 and install it onto
the Cart Frame 11.
2. Install two Clamping Block Rods 14 into a
Bottom Clamping Block 13 and install it onto
Cart Frame 11 with the image indicated in
Fig. 5 facing towards the top (towards the
handle).
3. Secure the clamping blocks to the Cart
Frame 11 by installing a Metal Washer 17,
followed by a Nut 19 onto each Clamping
Block Rod 14, then tighten the nut firmly in
place.
6
160992A919 GHT130 202309.indd 6
page heading
Assembly
Fig. 4
11
Fig. 5
13
6
14
12
11
17
19
9/27/23 3:48 PM
Publicidad
