Kärcher SC 5 Deluxe Manual Del Usuario página 13

Accessory storage area
6
Water reservoir
7
Main connection cable with main plug
8
Display - OFF position
9
Min. steam stage
10
Med. steam stage
11
Max. steam stage
12
VapoHydro function steam stage
13
Maintenance lock
14
Park bracket for floor nozzle
15
Steering roller
16
Steam gun
17
Steam lever
18
Unlocking button
19
Child lock
20
Steam hose
21
Steam connector
22
Spotlight nozzle
23
Round brush (small)
24
Round brush (large)
25
Power nozzle
26
Crevice brush
27
Manual nozzle
28
Manual nozzle cover
29
Extension tubes (2 x)
30
Unlocking button
31
Floor nozzle
32
Hook and loop fastener
33
** Floor cloth (1x)
34
Floor cloth (2x)
35
Carpet glider
36
Descaler
37
** Steam pressure iron
38
** Indicator light (orange)-heating
39
** Steam switch (bottom)
40
** Steam connector
41
** Accessories can be bought as an optional item
Installation
Installing accessories
1. Open the cover on the device socket.
Illustration B
2. Connect the steam connector to the device socket
so that the steam connector audibly engages.
Illustration B
3. Push the open end of the accessory onto the steam
gun so that the unlocking button on the steam gun
engages.
Illustration G
4. Push the open end of the accessory onto the spot-
light nozzle.
Illustration H
5. Connect the extension tubes with the steam gun.
a Push the 1st extension tube onto the steam gun
so that the unlocking button on the steam gun en-
gages.
The connection pipe is connected.
b Push the 2nd extension tube onto the
1st extension tube.
The connection pipes are connected.
Illustration I
6. Push the accessory and / or the floor nozzle onto the
free end of the extension tube.
Illustration J
The accessory is connected.
Disconnecting accessories
1. Move the child lock back.
The steam lever is locked.
2. Push the cover on the device socket down and dis-
connect the steam connector from the device sock-
et.
3. Press the unlocking button and pull the parts apart.
Illustration O
Operation
Filling water
The water reservoir can be removed at any time for fill-
ing or be filled directly at the device.
ATTENTION
Damage to the device
Unsuitable water can block the nozzles or damage the
water level indicator.
Do not fill in pure distilled water. Use a maximum of 50%
distilled water mixed with tap water.
Do not use condensation from the clothes dryer for fill-
ing.
Do not use collected rain water for filling.
Do not use cleaning agents or other additives (e.g.
scents) for filling.
Removing the water reservoir for filling
1. Pull the water reservoir vertically upwards.
Illustration C
2. Fill the water tank vertically with tap water or a mix-
ture of tap water and no more than 50% distilled wa-
ter.
3. Insert the water reservoir and press downwards until
it locks into place.
Filling the water reservoir directly on the device
1. Fill tap water or a mixture of tap water and no more
than 50% distilled water from a vessel into the filling
hole of the water reservoir up to the "MAX" mark.
Illustration D
Switching on the device
Note
If there is no or too little water in the steam boiler, the
water pump starts to run and pumps water from the wa-
ter reservoir into the steam boiler. The filling process
can take several minutes.