Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
A
Installing your Laurastar hygienic steamer
• Remove the unit from the box using the handle (14) and lay
it down on a flat, stable, heat-resistant surface (A).
Installing your filter cartridge
• Remove the packaging foil.
• Place the cartridge in the compartment at the bottom of
the water tank (C).
B
Use the supplied filter cartridge to fully enjoy your
Laurastar device for longer.
Filling the water tank
• Lift up the lid of the water tank, then remove it by pulling on
the lid (B). Fill it with tap water (D).
• Reinsert the water tank with the lid up, then close it.
What water should you use?
C
Your Laurastar hygienic steamer has been designed
to work with tap water (D).
For easier mobility of your hygienic steamer
around the house, use Laurastar IZZI CART
(available on our online store or from an official
Laurastar retailer).
NOTE: Never use additives (e.g. scented water),
D
water containing chemicals or water collected
from the tumble dryer, as these products will interfere with
the proper functioning of your Laurastar.
WARNING: The water tank MUST be filled with
water for the device to work.
DANGER! KEEP OUT OF THE REACH OF
CHILDREN. DO NOT DRINK THE FILTERED
WATER.
- 7 -
START UP AND STEP BY STEP
E
Turning on your device
• Plug in the electric plug (E).
F
• Press on the main switch (5), the white indicator light
will flash for 3 to 6 minutes (F).
• When the white light stops flashing, the device is ready.
3-6 min.
PLEASE NOTE: For your comfort and safety, Laurastar
hygienic steamer switches off after 10 minutes of
G
inactivity (G).
10 min.
PLEASE NOTE: Heating up the device without
water may damage it and will invalidate the
warranty of your device. Do not direct the steam
towards people or animals.
H
Protective Guard installation
(Textile-Guard and Surface-Guard)
• Take the DMS Steamer (2) in your hand (H).
PLEASE NOTE: Before starting to use the device or after
an extended break, press the steam button 2 or 3 times
I
(8) away from any surfaces or people (I). This is to drain
any condensation from the aluminium soleplate and
prevent water marks on fabrics or surfaces.
• Check that the installed Guard is the right one for your
use purpose and keep the other Guard within easy reach.
x2-3
• Place the front of the DMS Steamer (2) first at the front of:
- the Textile-Guard (15) if you want to use your hygienic
steamer on fabrics,
J
- or the Surface-Guard (16) if you want to use your
hygienic steamer on surfaces.
• Then lower it to attach the back of the Guard (J).
PLEASE NOTE: You may remove from the DMS Steamer
and change the guard while it is still hot.
CAUTION: The aluminium soleplate may be hot. Do
not leave the DMS Steamer in direct contact with
the material without any Guard as it may melt or burn it.
- 8 -
EN
Publicidad
