Publicidad
Idiomas disponibles
Idiomas disponibles
• Press on the STEAM button (8) to activate the steam (K).
K
• Place the DMS Steamer on the area to be disinfected.
0 cm
• Press the STEAM button (8) continuously. Make slow,
regular movements, touching the material, horizontally and
vertically and in all directions (L).
• To stop the steam, release the STEAM button.
• Remove the Textile-Guard or Surface-Guard after each use.
L
• Place the DMS Steamer back on the Steam Generator.
After disinfecting a surface, let it air-dry or wipe
0 cm
down using a clean cloth, which has first been
disinfected using your Laurastar IZZI (M).
ADVICE: For better mobility in the house, use an
extension cord if necessary. Please refer to the
M
technical instructions on page 13.
To better move your device around the house,
you can use a Laurastar IZZI CART (available
on our online store or from an official Laurastar
retailer).
N
beep
FILLING THE WATER TANK
Empty water indicator light (6) and sound signal
O
• A warning alarm sounds and a red indicator light comes on
to indicate that there is no water in the tank (N).
• You can fill up the water tank without having to turn it off first.
To fill the water tank (4)
P
• Lift up the lid of the water tank and remove it by pulling on
the lid. Fill it up with tap water (O).
• Reinsert the water tank with the lid up, then close it (P).
- 9 -
STORAGE
A
• Turn off the device by pressing the main switch (5) and
remove the power plug (10) from the wall socket (A).
• Remove the Textile-Guard or Surface-Guard after each
use.
2 hrs.
WARNING! Allow the device to cool down for
at least 2 hours before storing it away.
B
• Place the DMS Steamer (2) on the steam generator (B).
• Wrap the power cable (11) around the device (C).
If your model includes an automatic rewinder (only
available on IZZI Plus), pull the power cord to activate
the automatic rewind.
• Wrap the steam tube (3) around the device (C).
• You can leave water in the heater until the next use.
MAINTENANCE
C
COOL for at least 2 hours. It is best to clean the device
BEFORE use.
PLEASE NOTE: Only rinse the device with water. NEVER
use products for descaling or any other chemical
products.
D
MAINTENANCE OF DMS STEAMER AND
GUARDS
• Remove the Textile-Guard or Surface-Guard after each
use.
• Use a Laurastar soleplate cleaning mat (available on
our online store or from an official Laurastar retailer)
to wipe the dust, material and humidity residues
accumulated between the Guard and the aluminium
soleplate (D). Let the DMS Steamer dry out to avoid any
risk of corrosion.
- 10 -
WARNING: Before cleaning the
device, UNPLUG IT and leave it to
EN
Publicidad
