Publicidad
Idiomas disponibles
Idiomas disponibles
¸¸¸¸)¸¸¸¸¸¸¸¸7¸¸¸¸¸¸¸¸¸¸¸
(
CAUTION:
Operating
voltage
and frequency
requirement
of all electronic
equipment
should
be
checked
prior
to plugging
them into this generator.
Damage
may result
if the equipment
is not designed
to operate
within
a +/- 10% voltage
variation,
and +/-
3 hz frequency
variation
from the generator
name
plate
ratings.
To avoid damage,
always
have an
additional
load plugged
into the generator
if solid
state equipment
(such as a television
set) is used. A
power
line conditioner
is recommended
for some solid
state applications.
To avoid backfeeding into utility systems, isolation of the
residence electrical system is required.
Before temporary connection of the generator to the
residence electrical system, turn off the main
service/disconnect.
If your generator is to be used as a stand-by power source
in case of utility power failure, it should be installed by a
registered electrician and in compliance with all applicable
local electrical codes.
Proper use requires that a double throw transfer switch be
installed by a licensed qualified electrician so that the
building's electrical circuits may be safely switched between
utility power and the generator's output, thereby preventing
backfeed into the power utility's electrical system.
A power line conditioner should be used when running
one or more of the following solid state items:
Garage door openers
Kitchen appliances with digital displays
Televisions
Stereos
Personal computers
Quartz clocks
Copy machines
Telephone equipment
Other solid state equipment may require a power line
conditioner.
For more information, contact our Customer
Service Department at 1-800-445-1805 or
www.powerlnate.coin.
To avoid backfeeding
into utility
systems,
isolation
of
the residence
electrical
system
is required.
Before
temporary
connection
of a generator
to the residence
electrical
system
turn
off the main
switch.
Before
making
permanent
connections
a double
throw
transfer
switch
must be installed.
To avoid
electrocution
or property
damage,
only a trained
electrician
should
connect
generator
to residence
electrical
system.
California
law requires
isolation
of
the residence
electrical
system
before
connecting
a
generator
to residence
electrical
systems.
Temporary
connection
not recommended
due to backfeeding.
To avoid possible
personal
injury
or equipment
damage,
a registered
electrician
or an authorized
service
representative
should
perform
installation
and
all service.
Under
no circumstances
should
an
unqualified
person
attempt
to wire into a utility
circuit.
Always
follow local codes and regulations
that apply to
the installation
of any item that concerns
this product.
1.
NFPA 70 - National Electrical Code.
2.
NFPA 37 - Standard
for Installation and Use of
Stationary Combustible Engines.
3.
Agricultural Wiring handbook
of Farm Standby
Electric Power.
www.powermate.com
7
Customer Hottine 1-800-445-1805
Publicidad
