Publicidad
Idiomas disponibles
Idiomas disponibles
Gasoline
is very
dangerous.
Serious
injury
or death
may result
from
fire caused
by gasoline
contacting
hot surfaces.
1. Do not fill fuel tank with engine
running.
2. Do not spill fuel while refilling
tank.
3. Do not mix oil with gasoline.
4. Follow
all instructions
and warnings
in the engine
manual.
PRE-START PREPARATION
Before starting the generator, check for loose or missing
parts and for any damage which may have occurred during
shipment.
•
Provide
adequate
ventilation
for toxic exhaust
gases
and cooling
air flow.
•
Do not start
or run the generator
in an enclosed
area,
even if door or windows
are open.
•
Engines
give off carbon
monoxide,
an odorless,
colorless,
poison
gas.
•
Breathing
carbon
monoxide
can cause nausea,
fainting
or death.
APPLYING
LOAD
This unit has been pretested and adjusted to handle its full
capacity.
When starting the generator, disconnect
all load.
Apply load only after generator is running. Voltage is
regulated via the engine speed adjusted at the factory for correct
output. Readjusting will void warranty.
This generator
must
not be operated
without
all
factory
installed
heat shields
in place.
Failure
to
comply
may cause the fuel tank
to overheat
and result
in personal
injury
from
fire.
When
applying
a load, do not exceed the maximum
wattage
rating
of the generator
when
using
one or
more
receptacles.
Also, do not exceed
the amperage
rating
of any one receptacle.
STARTING
THE ENGINE
1.
Check oil level and fuel.
2.
Disconnect all electrical loads from the unit.
3.
Open fuel shut off valve.
4.
Adjust choke as necessary.
5.
Set the engine switch to the "ON" position.
6.
Pull on the starter rope with fast steady pull. As the
engine warms up, readjust the choke. On electric start
models, turn the key switch to "START". Release key
switch after the engine starts.
SHUTTING
THE GENERATOR
OFF
1.
Remove entire electrical load.
2.
Let the engine run for two minutes without load.
3.
Move the engine switch to the "OFF" position. (Turn
the key switch to "OFF" on the electric start models).
4.
Do not leave the generator until it has completely
stopped.
5.
Close the fuel shut off valve if the engine is to be put in
storage or transported.
6.
If a cover is used, do not install until unit has cooled.
Allow generator
to run at no load for five minutes
upon each initial
start-up
to permit
engine
and
generator
to stabilize.
www.powermate.com
1 0
Customer Hottine 1-800-445-1805
Publicidad
