Homelite UT10522 Manual Del Operador página 13

FILLING THE FUEL TANK
See Figure 2.
 Clean the surface around the fuel cap to prevent
contamination.
 Loosen the fuel cap slowly.
 Carefully pour the fuel mixture into the tank.
Avoid spillage.
 Prior to replacing the fuel cap, clean and inspect the
o-ring.
 Immediately replace the fuel cap and hand
tighten. Wipe up any fuel spillage.
NOTE: It is normal for the engine to emit smoke
during and after the first use.
OPERATION
ADDING BAR AND CHAIN LUBRICANT
See Figure 3.
Use HOMELITE Bar and Chain Lubricant. It is
designed for chains and chain oilers, and is
formulated to perform over a wide temperature
range with no dilution required. Chain saw should
use approximately one tank of lubricant per tank
of fuel.
NOTE: Do not use dirty, used, or otherwise con-
taminated lubricants. Damage may occur to the
oil pump, bar, or chain.
 Carefully pour the bar and chain lubricant into
the oil tank.
 Fill the oil tank every time you fuel the engine.
Fig. 2
Page 13 — English
Fig. 3