Homelite UT10522 Manual Del Operador página 27

MAINTENANCE
The chain is correctly tensioned when there is no
Rotate clUtch coVeR lock
sag on the underside of the guide bar, the chain is
knob clockwise to secURe
snug, but it can be turned by hand without binding.
Ensure that the chain brake is not set.
NOTE: If chain is too tight, it will not rotate. Loosen
the clutch cover lock knob by pressing in and
slightly rotating counterclockwise, then rotate the
chain tensioning dial counterclockwise. Lift the
tip of the guide bar up and retighten the clutch
cover lock knob securely. Ensure that the chain
will rotate without binding.
adjUsting
pin
chain clUtch coVeR
Fig. 40
tensioning dial lock knob
Fig. 41
chain tensioning
pin hole
clUtch
coVeR
spRocket
tighten loosen
chain
chain
Fig. 39
Fig. 42
Page 27 — English