Publicidad
Idiomas disponibles
Idiomas disponibles
WHEN THERE ARE NO EXISTING UTILITY
CONNECTIONS
PREPARE TO CONNECT POWER SUPPLY
Connect to the Power Supply using one of two Methods: Direct Wire
Cable (Method 1) or Power Cord (Method 2). Follow the instructions
specific o your installation.
WARNING
Electrical Shock Hazard
•
Disconnect electrical power at the fuse box or circuit
breaker box before installing dishwasher.
•
Failure to do so can result in death or electrical shock.
Method 1 - Direct Wire
3/4
Drill a
" (1.9 cm) hole into the right-hand cabinet, or the right-hand
1.
side of the back wall or floor of the opening. See ollowing graphic for
preferred and optional locations.
NOTE: Wiring the dishwasher will be easier if the wire is routed into the
opening from the right-hand side.
b
2.
Smooth or cover rough edges of the hole that the wiring will pass
through.
Wood Cabinet - Sand edge of hole until smooth.
Metal Cabinet - Cover edge of hole with grommet (not provided).
3.
Route the cable from the power supply through the hole (cable must
extend to the front, right-hand side of the opening). Extend cable to 6"
(15.2 cm) in front of unit and tape the cable to the floor o keep it from
moving when dishwasher is moved into the cabinet opening.
NOTE: You can tape the wire to the floor to secure it while dishwasher is
moved into place.
a
6" (15.2 cm)
a
Preferred
Locations
b
Optional Locations
direct
wire
tape
3" to
1/4
4
"
(7.6 cm to
0 0 0
cm)
10.8
17
Publicidad
