Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Attach copper tubing to the manual shutoff valve.
a
3.
Slowly feed the copper tubing through the hole into the opening.
Continue feeding the tubing, until there is enough length to connect to
the inlet (front, left-hand side of the dishwasher) yet remain within the
required boundary.
¾
3" to 4
(7.6 cm to 12.1 cm)
4.
Slowly turn water shuto˜ v alve to "ON" position. Flush water into a
shallow pan to get rid of particles that may clog the inlet valve.
5.
Turn shuto˜ v alve to "OFF" position.
NOTE: You can tape the hose to the floor to secure it while dishwasher is
moved into place.
PREPARE TO CONNECT DRAIN HOSE
The drain hose will be connected to the house drain system after the
dishwasher is installed in the opening.
1/2
1.
Drill a 1
" (3.8 cm) hole in cabinet wall or floor on the side of th
opening closest to the sink.
b
a
"
a
Preferred Locations
b
Optional Locations
a
Copper Tubing
19
Publicidad
