Publicidad
Automotive current tester / English
OPERATING INSTRUCTIONS FOR RELAY BUDDY
1. Connect the power leads to the car battery – black alligator clip to negative terminal, red
alligator clip to positive terminal.
2. Tester is powered up when the LED illuminates in RED.
3. Check the relay before plugging into the tester. If it's a 4 pin relay, select "4 pin" on the
tester. If it's a 5 pin relay, select "5 pin" on the tester.
4. Plug in the relay into one of the three receptacles.
5. Press the "Test" button.
6. Tester will open and close the relay 10 times. If the test is successful and the relay is good,
the LED will illuminate in GREEN. If the relay is bad, the LED will illuminate in RED.
7. Disconnect power leads from the car battery and remove relay from the tester.
Warranty Information
This product is warranted to be free from defects for one year. If this product fails during the
first 12 months due to faulty materials or workmanship, it will be repaired or replaced free of
charge, at the discretion of the manufacturer.
NOTE: This one year warranty does not cover dead batteries and blown fuses.
Defective units being returned to your dealer or to the factory should include proof of
purchase date.
Any testers that do not function due to misuse or abuse will be subject to "out of warranty
service charges.
2
Manuel d'instructions
RS CF-02
Numéro de stock: 200-3704
Testeur de courant automobile
FR
Publicidad
