Publicidad
Idiomas disponibles
Idiomas disponibles
ROBO WH
Equipping the ROBO WH 241D / 455D torch neck
Abb. / Fig. 1 on page -1
NOTICE
• Ensure that wear parts specific to the welding torch are correctly assigned.
• Only screw wear parts in and out with a switch key wrench.
1 Screw the replaceable tip adaptor (5) into the torch neck (6).
2 Screw the contact tip (4) into the tip adaptor (5) and tighten it using a multiple wrench.
3 Screw the welding spatter guard (3) into the torch neck (6).
4 Slide the gas nozzle (1) on the torch neck (6) rotating it slightly clockwise.
5 Screw in the ready-to-use equipment kit (7) on the connection side.
Maintenance and cleaning
Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-free
operation.
NOTICE
• Clean the welding torch during each welding break if there is heavy weld spatter.
• Only screw wear parts in and out with a switch key wrench.
1 Clean the joints.
2 Lubricate the O-rings lightly with a silicone-free grease.
3 Check the wear parts for visible damage and replace them, if necessary.
BEI.0037 • 2020-12-14
EN - 3
Publicidad
