INSTRUCTIONS
Sampling
operation
Detection
operation
●
Clamp the power clip of the main unit to the 12V battery, and
be careful not to connect the positive and negative reversely or
short-circuit with the vehicle.
●
Use the injection sampler to suck the brake fluid, take out 50ml
of fluid, and then fill it into the beaker to be tested.
CAUTION
The brake fluid to be tested should be filled into the beaker
over the 40ml scale and not more than 50ml.
●
Put the test stick into the beaker and make sure the sampling
hole of the test stick is immersed in the brake fluid and the air
bubbles are bled from the cavity inside the test head to avoid
affecting the test results.
●
Do not shake, knock or drop the test head (heater bar) to avoid
injury to the sensor and other parts.
●
The red power clamp is connected to the positive of the
battery, and the black power clamp is connected to the nega-
tive, and then the tester is automatically powered on.
●
Select measurement mode: normal mode or brand mode.
●
Select the brand and brake fluid type (DOT3\DOT4, etc.).
●
After entering the ready interface, press and hold the S button
for about 16s, and wait for the progress bar to run full to
complete the test. During the test, the live fluid temperature
and battery voltage will be displayed.
●
When the test is complete, remove the unit vertically to avoid
brake fluid from being spilled.
4