Erreka KM-400S Manual De Instrucciones página 25

1.Fastening the motor in position:
- Fix the plate to the ground, taking into account the general dimensions of the motor.
- Fasten the motor to the plate.
2.Fastening the rack in position:
- Fasten the rack to the gate, taking into account the dimensions of the motor on the ground.
- If necessary, compensate the height of the motor with height-adjustment screws.
- Fit the mechanism to the base by tightly screwing the Allen lock-screws.
- Check the adjustment between the two by placing the mechanism in manual position and moving the gate along the rack. Leave a
small clearance space so that the motor does not bear the weight of the gate. Once you have checked the adjustment, fasten the rack
in its final position.
Fit the end stops in approximate positions on the rack. The magnet goes in the middle hole. It is recommended that you fit stops to
the gate in open and closed positions to prevent the gate from sliding beyond the area of influence of the end stops.
- Lock the motor.
25