Uline Kihlberg H-1335 Manual Del Usuario página 2

STAPLE PENETRATION DEPTH
Push knob in and turn to the desired position:
(See Figure 1)
– For shallow stapling
= For deep stapling
STAPLE LEG LENGTH
Stapler adapts to use of 15 or 18 mm staples.
1. Loosen the locking screw underneath with 2.5 mm
Allen wrench. (See Figure 2)
2. Set desired staple leg length. Tighten the locking
screw. (See Figure 3)
Figure 2
3. Loosen bolts on side guides with 2.5 mm Allen
wrench. Adjust for staple size. "Outer" position
denotes 18 mm. "Internal" denotes 15 mm. Tighten
bolts when finished. (See Figure 4)
PAGE 2 OF 9
OPERATION CONTINUED
Figure 1
18 mm 15 mm
Figure 3
Figure 4
Side Guides
STAPLE CLOSURE
For a tighter staple closure:
Turn the adjusting nut to the
left. (See Figure 5)
For a looser staple closure:
Turn the adjusting nut to the
right. (See Figure 5)
LOADING
1. Squeeze magazine lid and pull backward to open.
(See Figure 6)
2. Place staple roll into magazine. Feed up to side
guides. (See Figure 7)
NOTE: Ensure staple roll feeds from bottom
of roll.
Figure 7
3. Close and press lid down to lock.
Figure 5
Figure 6
Magazine Lid
0424 IH-1335