SPIDO ECA 550 Manual De Instrucciones Original página 15

3. TECHNICAL DATA
Model
Mains voltage / frequency
Power consumption
Max. flow rate
Total pressure head Max.
Depth of immersion Max.
Water temperature Max.
Power cable
Protection Class
Weight
Dimensions (mm)
Outlet connection
Size of solid particles pumped Max.
4. AUTOMATIC MODE
1. The pump switches on when the rising wa-
ter reaches the sensor
The pump starts then stops to carry out de-
gassing then starts pumping Metal contacts
at the bottom of the sensor strip detect the
minimum water level(switch-off point).When
the minimum water level is reached, the
pump stops after a delay.
2. Fit the sensor onto the sensor strip in the
desired switch-on position.
5. MANUAL MODE
The pump is switched on when the sensor is
ECA550
inserted in the top-most position of the sen-
sor strip.
220-240 V
The pump is then in forced operation and will
50 Hz
only stop when the user has unplugged it
550 Watts
This manual mode therefore requires extreme
15 000 l/h
vigilance but allows the pump to reach the
maximum drying level.
8 m
Metal contacts at the bottom of the sensor
7 m
strip detect the minimum water level(deacti-
35 ºC
vation point) .When the minimum water level
is reached, the pump switches off with a brief
H05RNF - 10 m
delay.
IPX8
Repeat the process: reinsert the sensor in the
4,8 kg
top position of the sensor strip.
250x250x390
F40/49 (1"1/2)
35 mm
6. INSTALLING THE PUMP
1. Install the pump on a horizontal, stable sur-
face in the water.
2. If it needs to be lowered into a well or a
shaft, fasten a rope to the handle.
Do not carry it by the power connection cable.
7. OPERATION WARNING
1.Only Operate the pump if no persons are
in water
2. Disconnect all electrical devise in the water
from the power supply before reach into the
water.
tion will reduce the pump service life accor-
dingly
Risk of severe injuries or death by
electric shock
The pump is not suitable for conti-
nuous operation. Continuous Opera-
GB