Publicidad
Idiomas disponibles
Idiomas disponibles
„ When powered and connected to the mower, the LED
indicator on the charger will illuminate to indicate the
charger's status. See the chart that follows to determine
the meaning of the LED's display.
„ When you are ready to mow, disconnect the charger from
the power supply, then disconnect the charger from the
mower.
NOTICE:
Always turn power switch to OFF position and remove
key when charging mower and when mower is not in use.
NOTICE:
Always connect the mower to the charger when the unit
is not in use. If it is not possible to leave the mower char-
ger connected, make sure to charge the batteries fully at
least once a month.
CONNECT
STATUS
AC
Standby
YES
Charging
YES
Charger Error
YES
Fully Charged
YES
Pack Defective
YES
If charger is connected to both power supply and mower, and an error condition exists. Disconnect charger from mower,
perform a suggested remedy below, then try charging again.
• Remove debris from charger/mower connection
• Allow hot batteries to cool
• Lower over voltage batteries by running the mower to discharge
• Verify mower battery series configuration is correct
• Clean charger cooling fins and if hot, allow to cool
OPERATION
CONNECT
CHARGER
RECEPTACLE
GREEN LED
NO
ON
YES
ON
YES
OFF
YES
ON
YES
ON
15 — English
CHARGING
PORT
LED INDICATOR
ON CHARGER
RECEPTACLE
GREEN LED
Charger may be connected to power supply
OFF
but not connected to mower.
SLOW FLASH
Charger is fully connected and mower bat-
(500ms ON/500ms
teries are charging.
OFF)
Charger is connected to mower but is not
FAST FLASH
connected to power supply. Batteries or
(200ms ON/200ms
charger are too hot or too cold. Once normal
OFF)
temperature is reached, charging will begin.
ON
Batteries are fully charged.
Batteries are deeply discharged. Once
FAST FLASH
voltage is reached, charging will begin. If
(200ms ON/200ms
charging does not occur, the battery packs
OFF)
could be defective.
CHARGER
PLUG
Fig. 5
Fig. 6
DESCRIPTION
Publicidad
