Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
1.
Shut off the water at the supply valves under the sink or at the
main water supply. Disconnect the supply lines. Remove the
existing faucet from the sink.
Clean and dry the surface area where the new faucet will be
mounted.
2.
Remove the preassembled lock nut (CC), metal washer (BB),
rubber washer (AA), and hex bolts (DD) from the faucet body (A).
Hardware used
Rubber washer
AA
Metal washer
BB
Lock nut
CC
Hex bolts
DD
3.
To install with the optional deckplate for a 3-hole sink, skip to
step 4.
Carefully insert the integrated water supply lines (3.1) and shank
(3.2) on the faucet body (A) through the mounting hole in the sink
(3.3). From underneath the sink, secure the faucet body (A) to the
sink using the rubber washer (AA), metal washer (BB), and lock
nut (CC). Tighten the lock nut by using the hex bolts (DD).
Skip to step 6.
4.
OPTIONAL DECKPLATE INSTALLATION:
Apply a thin bead of silicone to the underside of the gasket (C).
Place the gasket (C) and deckplate (B) over the mounting holes in
the sink, aligning the center hole in the gasket (C) and deckplate
(B) with the center mounting hole in the sink (4.1).
Carefully insert the integrated water supply lines (4.2) and shank
(4.3) on the faucet body (A) through the hole in the deckplate (B)
and gasket (C), and the mounting hole in the sink (4.1) until the
faucet sits on top of the deckplate (B).
x 1
x 1
x 1
x 2
4
1
2
AA
BB
CC
DD
3
3.3
3.2
AA
BB
CC
DD
3.1
4
B
C
4.3
4.2
A
DD
A
DD
A
4.1
Publicidad
