Publicidad
Idiomas disponibles
Idiomas disponibles
7.4 Stop terminal switch (NO/NC)
p1
p6
s0
s1
s0
7.3.5 Instructions: The height of ventilation position is calculated
from the close limit. If the setting position is bigger than the
open limit, it can only be opened to the open limit. After the
door is completely closed, press the ventilation key on the
remote control, and the door will open and stop at the
ventilated position set.
7.3.6 If "r0" is set, the door can be controlled by the ventilation
key after learning. If "r1" to "r9" is set, the ventilation key can only
control the open ventilation position, and other keys must be
learned to control the door.
7.4.1 Press and hold SET, it displays "P1".
7.4.2 Press UP ten times, it displays "PA", press SET to show
current situation.
7.4.3 Press the "UP arrow" or "DOWN arrow" key to adjust the
setting. "S0": shows that the STOP terminal is normally open
(NO); "S1": shows STOP terminal is normally closed (NC); press
the "P" button to save and return to standby state.
7.4.4 Default setting: "S0".
12
Code: SC1800
Publicidad
