Publicidad
Idiomas disponibles
Idiomas disponibles
SUPPLIER'S DECLARATION OF CONFORMITY
Brand: BaBylissPRO
®
Model No.: FX787N
Description: Trimmer
Responsible Party: Conair LLC
1 Cummings Point Road
Stamford, CT 06902
(203) 351-9000
Standards: FCC Part 15 Subpart B, ANSI C63.4-2014
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesirable operation.
DATE OF ISSUE: 11/16/2023
FOR DIRECT PLUG-IN OPERATION OR CHARGING
Make sure trimmer is off. Connect a standard charging cable into the standard charging
jack at the bottom of the trimmer and plug the power adapter into a power outlet. Note:
Direct plug-in operation is only possible using the standard charging cable. The trimmer
will not turn on while charging via a USB-C cable.
USB-C CHARGING INSTRUCTIONS
Make sure trimmer is off. Connect a USB-C cable to the USB-C
charging port at the bottom of the trimmer and plug the USB-C cable
into a certified USB power source to begin charging. Note: Trimmer
will not turn on while charging via a USB-C cable.
ON/OFF SWITCH
To turn on, slide switch to the "I" position. To turn off, slide switch to the "O" position.
FX787N IB-18020A.indd 7-8
FX787N IB-18020A.indd 7-8
VERY IMPORTANT: Blades must be cleaned and oiled on a regular basis for
proper functioning. Failure to regularly clean and oil the blades will void the
warranty.
REPLACING (REMOVING) BLADE SET
To remove the blade set, turn the trimmer to the
"O" position and unplug it from the electrical outlet.
Turn the trimmer upside down so that the teeth of
the trimmer are facing down. Place the trimmer on
a flat surface and using the screwdriver, loosen the
fastening screws from the blade set. Remove the
blade set from the trimmer (see Fig. 1).
To install or replace your trimmer blade set, reverse the procedure, aligning the blade
cushion shaft into the moving blade cushion (see Fig. 2). With the blade held in place,
replace blade screws and loosely tighten. Turn the trimmer over and align the blade set
parallel to the trimmer's upper housing.
Screws
Fig. 2
Blade cushion
Moving blade
Fixed blade
Screws
BLADE CARE
Because the trimmer blades are precision-made for a very special use, they should
always be handled with care and cleaned regularly to ensure maximum performance.
Each time you finish using the trimmer, take the cleaning brush provided and brush
away any loose hair that has collected in the blades.
Any other servicing should be performed by an authorized service representative, since
the appliance has no other user-serviceable parts. This product is for commercial use.
Blade set
Fig. 1
Blade screws
Screw holes
2023/11/1 15:18
2023/11/1 15:18
Publicidad
