Connecting The Battery - Sabre 1336HR Manual Del Operador

eng 10
Push the pin in using a hammer, ensuring that it comes completely through to the
opposite side.
NOTE
the same size as the pin to push it in the last part.
FITTING THE SEAT
The seat (1) is supplied attached to a
support bracket (2) on which has been fit-
ted a micro-switch (3). Fit the support
bracket (4) using the screw pins (5) sup-
plied, fully tightening the relative nuts (6).
ATTENTION!
!
from the general wiring (8) to ensure that the safety device works, and
then fit the wire into the wire-holder (9)

CONNECTING THE BATTERY

The battery (1) is situated in a compart-
ment under the seat and is held in place
by a spring (2).
Connect the two red cables (3) to the
positive terminal (+) and the black cable
(4) to the negative terminal (–) using the
supplied screws and following the illustra-
ted sequence.
Recharge the battery according to the
manufacturer's instructions
IMPORTANT
ting in, never start the engine until the battery is fully charged!
ATTENTION!
!
safe handling and disposal.
To avoid damaging the hub, use an awl or a screw-driver of
Connect the micro-switch socket (7) to the one coming
To prevent the safety device in the electronics card from cut-
Follow the battery manufacturer's instructions regarding
UNPACKING AND ASSEMBLY
2
3
7
8
6
5
4
3
4
1
9
4
1 2