Descargar Imprimir esta página

Briggs & Stratton SNAPPER G1000 Manual Del Propietário página 13

Ocultar thumbs Ver también para SNAPPER G1000:

Publicidad

Idiomas disponibles

Idiomas disponibles

S 4PPER
TM
bye&
Sfrafton
°
_
POW_R P_ODU_S
SPECiFiCATiONS
Rated Surge Watts
........................
1,000 Watts
Rated Running Watts ........................
900 Watts
Rated Maximum Current
At 120 Volts AC
..........................
7.5 Amps
At 12 Volts DC ...........................
8.3 Amps
Phase ....................................
Single Phase
Rated Frequency .............................
60 Hertz
Packaged Weight ..............................
61.0 Ibs.
GENERAL
MAINTENANCE
RECOMMENDATIONS
The Owner/Operator
is responsible
for making sure that
all periodic
maintenance
tasks are completed
on a timely
basis; that all discrepancies
are corrected;
and that the unit
is kept clean and properly
stored.
NEVER
operate
a
damaged
or defective
generator.
Engine
Maintenance
See engine owner's
manual for instructions.
CAUTION
. Used
motor
oil has been shown
to cause skin cancer
in
certain
laboratory
animals.
. Thoroughly
wash
exposed
areas with soap and water.
KEEP OUT OF REACH OF CHILDREN.
DON'T
POLLUTE. CONSERVE RESOURCES. RETURN
USED OIL TO COLLECTION
CENTERS.
Generator
Maintenance
Generator
maintenance
consists
of keeping the unit clean
and dry. Operate
and store
the unit in a clean dr),
environment
where
it will not be exposed
to excessive
dust, dirt, moisture
or any corrosive
vapors.
Cooling
air
slots in the generator
must not become
clogged with snow,
leaves or any other
foreign material.
NOTE:
DO NOT use a garden hose to clean generator.
Water
can enter
engine fuel system and cause problems.
In
addition,
if water
enters
generator
through
cooling air
slots, some of the water will be retained
in voids and
cracks of the rotor
and stator winding
insulation.
Water
and dirt buildup
on the generator
internal
windings
will
eventually
decrease
the insulation
resistance
of these
windings.
WARNING
WHEN
ADJUSTING
OR MAKING
REPAIRS
TO YOUR
GENERATOR
" Disconnect
the spark
plug wire from the spark plug and place
the wire where
it cannot
contact
spark
plug.
WHEN
TESTING
FOR ENGINE
SPARK
Use approved
spark
plug tester.
DO NOT
check for spark with spark plug removed.
Generator
Cleanin
• Use a damp cloth to wipe exterior
surfaces
clean.
CAUTION
o
o
o
DO NOT
expose
generator
to excessive
moisture,
dust, dirt,
or corrosive
vapors.
DO NOT insert any objects through cooling
slots.
Use a soft bristle
brush to loosen caked on dirt or oil.
Use a vacuum
cleaner
to pick up loose dirt and debris.
Use low pressure
air (not to exceed
25 psi) to blow
away dirt. inspect cooling air slots and opening
on
generator.
These openings
must be kept clean and
unobstructed.
13

Publicidad

loading