Andis CCA Instrucciones De Uso Y Cuidado página 10

CARE AND SERVICING OF YOUR ANDIS CLIPPER BLADES
The blades should be oiled before, during, and after each use. If your clipper blades
leave streaks or slow down, it's a sure sign that the blades need oil. The clipper
should be held in the position shown in Figure D to prevent oil from getting into the
motor. Place a few drops of Andis Clipper Oil on the front and side of the cutter
blades (Figure E, Figure I). Wipe excess oil off the blades with a soft dry cloth. Spray
lubricants contain insufficient oil for good lubrication, but are an excellent clipper
coolant. Discontinue use of broken or nicked blades to prevent injury. You can clean
the excess hair from your blades by using a small brush or an old toothbrush. To
clean the blades we suggest immersing the blades only into a shallow pan of Andis
Blade Care Plus while the clipper is running. Any excess hair and dirt that has
accumulated between the blades should come out. After cleaning, turn your clipper
off, dry the blades with a soft, dry cloth and start using again. For more information
on how to care for your clipper and view how-to tutorials, visit andis.com.
WARNING: Cutting blades may become hot after prolonged use.
BLADE TEMPERATURE
Due to the high speed nature of Andis clippers, please check for blade heat often,
especially on close cutting blades. If blades are too hot, dip the blades only into
Andis Blade Care Plus or apply Andis Cool Care Plus and then Andis Clipper Oil.
REMOVING BLADE SET
To remove the blade set, first make sure your clipper motor is switched "Off". Push
blade release mechanism under blade hinge. While holding down the blade release
mechanism, push down on blade, then gently pull the blade forward (Figure F) and
slide it off the blade hinge (Figure G). If your blade hinge should snap closed and is
flush with the clipper, use a small standard screwdriver to pry the tongue of the
hinge out (Figure H).
MOUNTING AND DISMOUNTING THE BLADE SET
To replace or change your blade set, slide the blade bracket onto the hinge of the
clipper (Figure G), and with the clipper turned "ON", push the blade towards the
clipper to lock into position.
CHANGING THE BLADE DRIVE ASSEMBLY
If your clipper blades no longer cut properly (be sure to try more than one blade,
since the blade currently being used may be dull), it could be that your blade drive
assembly needs replacement.
10