LawnMaster CLGT2410T Manual Del Operador página 26

MAINTENANCE
CAUTION
After changing the spool, run the trimmer under no load (i.e. away from grass and weeds) for at least
a minute to verify the line and the tool are both operating correctly. Use only the spool and line as
recommended by the manufacturer.
LINE REPLACEMENT
1. Remove the battery pack.
2. Remove the spool from the trimmer head. Remove any old line remaining on the spool.
NOTE:
3. Cut a piece of line approximately 16.4 ft. (5 m) long.
4. Insert the line into one of the two anchor holes found on the upper part of the spool. Wind the line
around the spool clockwise as shown by the arrows on the spool (Fig. 22).
Anchor
Hole
Spool Cover
Tabs
Spool
Eyelet
Fig. 21
Slot
Fig. 22
26