Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
WARNING
adjusting, inspecting, or cleaning the grass trimmer.
CLEANING
1. Clean the product with a dry cloth. Use a brush for areas that hard to reach.
2. In particular clean the air vents after every use with a cloth and brush. Keep the air vents free of
obstructions, sawdust, and wood chips. Do not spray, wash, or immerse the air vents in water.
3. Remove stubborn dust with high pressure air (max. 3 bar).
NOTE: Do not use chemical, alkaline, abrasive or other aggressive detergents or disinfectants
to clean this product as they might be harmful to its surfaces.
4. Check for worn or damaged parts. Replace worn parts as necessary or contact an authorized
service center for repair before using the product again.
5. Keep the safety guard clean and free of debris. Remove trimmings. Replace the guard with a one
of the same type when it's worn or shows damage.
SPOOL REPLACEMENT (FIG. 21)
WARNING
Always remove the battery prior to replacing the line spool. Failure to do so, can cause serious injury!
The trimming line cut-off blade, located on the debris guard is sharp. Take extra care and wear
protective gloves.
replacement line for best performance.
2. Remove the battery pack.
3. Push in tabs on both sides of the spool cover.
4. Pull the spool cover up to remove.
5. Remove the spool.
NOTE: Always clean the spool cover and spool base before reassembling the trimmer head.
6. Check the spool cover, spool, and spool base for wear. If necessary, replace the worn parts.
7. To install the new spool, make sure the line is captured in the spool slot on the new spool. Make
sure the end of the line is extended approximately 6 in. (152 mm) beyond the slot (Fig. 22).
8. Install the new spool so that the line and slot are aligned with the eyelet in the line head. Thread the
line into the eyelet.
9. Pull the line extending from the eyelet so the line releases from the slot in the spool.
10.Reinstall the spool cover by depressing tabs into slot in the trimmer head and pushing down until
spool cover clicks into place.
NOTE: Use LawnMaster
®
spool model # 121003116 for replacement.
25
Publicidad
