Publicidad
Idiomas disponibles
Idiomas disponibles
EN
6
TROUBLESHOOTING
Problem
The handle is not in position.
The product does not start.
The product cuts grass unevenly.
The product does not mulch correct-
ly.
The product is hard to push.
There is a high vibration in the prod-
uct.
The product stops during mowing.
* If you cannot find the solution to these problems, consult your nearest service center.
7
TECHNICAL DATA
Voltage
Deck size
Battery model
Charger model
No load speed
Possible cause
The bolts are not engaged correctly.
The battery capacity is low.
The blade engagement lever is de-
fective.
The blade height is too low.
Wet grass clippings become tangled
in the deck.
The mulch door is missing.
The grass is too tall, or the blade
height is too low.
The grass catcher and the blade
drags in thick grass.
The blade is unbalanced and worn.
The motor shaft is bent.
The blade height is too low.
The battery is out of power.
The grass clippings become tangled
in the deck or blade.
Operation temperature of the prod-
uct is too high.
60 V
22" (55.9 cm)
LB605/LB6051 and other BAC
series
CAC801 and other CAC series
2700/3000 RPM
English
Height adjust-
ments
Functions
IPX
18
Solution
Adjust the height of the handle and
make sure that the bolts and nuts
are aligned correctly.
Charge the battery.
Replace blade engagement lever.
Move the wheels to a higher posi-
tion.
Wait until the grass dries before
mowing.
Install the mulch door.
Increase the blade height.
Empty the grass clippings from the
grass catcher.
Replace the blade.
1.
Stop the motor.
2.
Remove the battery.
3.
Disconnect the power source.
4.
Inspect for damage.
5.
Repair the product before you
start it again.
Increase the blade height.
Charge the battery.
Remove the battery and check the
deck.
Turn off and move to shaded area
for 10-15 minutes.
1-4" (2.5-10.2 cm)
3-in-1 Mulch & Rear Bag & Side
discharge
IPX4
Publicidad
