Publicidad
Idiomas disponibles
Idiomas disponibles
Initial start-up - When the spa is first powered
up, the control system begins a 2 minute Startup
Mode. Different codes will display on the screen.
Once Startup Mode completes, the actual
temperature is displayed on the screen. The spa
will then begin to heat and maintain the water
temperature and the first filter cycle will start. Your
spa has been designed so that it will automatically
heat the water to the factory set temperature of
100°F (38°C) unless you set the spa to a different
temperature. If power is disconnected from the
spa, it will automatically revert back to the last
saved set temperature when power is reapplied.
Depending on your spa model you will either
have a one pump or two pump control panel as
illustrated.
TEMPERATURE
ADJUSTMENT
The temperature can only function between
80°F - 104°F (26.5°C - 40°C). The last
measured temperature will constantly display
on LCD.
1 Pump Model - Press the Up or Down buttons
to display the set temperature and indicator
Each time either button is pressed again, the set
temperature will increase or decrease depending
on which button is pressed. After five seconds,
the LCD will automatically display the current spa
temperature.
1 Pump
Indicator Lights
Jets Light
2 Pump
Indicator Lights
Jets 1
Jets 2
2 Pump Model - Press and hold the Temp button,
the temperature will either go up or down. Release
CONTROL PANEL OPERATION
Temp Down
Temp Up
Light
Temp Up/Down
when desired temperature is achieved. If desired
temperature is in the opposite direction, press and
hold a second time to adjust the temperature and
release when desired temperature is achieved.
The "Heat" indicator
It flashes when there is a request for more heat.
Once set temperature is reached the indicator
shuts off, on the 230 volt models only the low
speed of the jet pump turns off after 30 seconds (if
not in filter cycle).
JETS OPERATION
Firmly press the Jets (1) button once to
activate the low speed of the pump and
again for the high speed. Firmly press the
Jets (1) button again to turn off the pump. If
left running the low or high speed pump will
automatically turn off after 1 hour. The "Jets"
indicator light next to the button will blink
when jet pump is on low speed and is solid
on high speed. On 2 pump models, press the
Jets (2) button once to activate jet pump 2 on high
and press a second time to turn jet pump 2 off
MULTI COLOR LED LIGHT
Press the Light button once to turn on the light, the
.
light indicator next to the button is lit when the light
is on. Press the button again to turn the light off.
Every time the light is quickly turned off and on a
new light mode will appear. The sequence is as
follows: White, Full color wheel, Amber, Blue, Red,
Green, Purple, Color wheel 1, Color wheel 2 and
abrupt color wheel. The last light mode used will
come back on when the light is turned off for more
than 2 seconds.
NOTE: If left on, the light will automatically turn off
after 4 hours of operation.
FILTER CYCLES
There are two filter cycles, the first cycle (F1)
starts right after power up and the second
cycle (F2) will start 12 hours later. The default
duration for the first filter cycle is 1 hour, and
30 minutes for the second cycle. Filter cycles
only run at low speed. The "Filter" indicator
lights up when a filter cycle is on. The
duration of each filter cycle can be modified.
11
lights up when heating.
Publicidad
